Car Fuel Injector Tester 12V Flushing Nozzles Pulse Pressure Machine Cleaning

Description

Car Fuel Injector Tester 12V Flushing Nozzles Pulse Pressure Machine Cleaning
Description
Used to test automobile injectors to determine whether the fuel injectors are stuck, leaking, or burning. It is possible to set multiple pulse outputs and adjust speed, pulse width, operating time and other parameters as required. It is also possible to connect two nozzles for the simultaneous operation to compare the sprayability status and the spray angle of the fuel injector.
Features:
Easily solve common faults such as stuck, blocked, leaked, or insufficient combustion of the fuel injector.
The pulse width and RPM can be continuously adjusted and different programs can be applied to drive the injectors.
During the cleaning process, pulse cleaning can be achieved by adjusting the RPM and width to optimize the cleaning effect.
Can be used with any fuel pressure tester.
This device can also be used with ultrasonic cleaners and older fuel injector testers. The drive mode of the GDI engine injector added to this machine can be used as an upgrade kit for the old version of the machine (machine without GDI drive).
Operation Instruction:
Turn off the vehicle's engine and remove the fuel injectors from the engine.
Connect the pulse output to the power input port on the fuel injector.
Connect the positive and negative electrodes clamps to the 12V battery.
Press RPM "+" "-" key to select the required analog speed. Press "Start" button, then the device starts working.
Select the required injector.
Put the device into the connection equipment, and then press the carburetor cleaner.
Press RPM "+" and "-" keys, the tester will output pulse to the injector, and then the pulse signal indicator will light up. The device will start working.
Use self-pressure detergent, you need to select the corresponding connector and connect it well. Press the start button to start spraying, and observe the sprayability status and spray angle with your naked eye.
Precautions:
Make sure the car engine must be turned off before using this device.
Do NOT smoke or light near the car.
Do not spill the car's fuel on hot engine parts.
Perform this device in a well-ventilated place only .
Do NOT approach any rotating parts of the car, and do NOT touch any heating parts of the car. Do NOT touch any car parts with dangerous voltage logo.
Wear qualified goggles.
Package Included
1 x Car Fuel Injector Tester